Unit of competency Outline

Date retreived
23/07/2026 4:47 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Install unpatterned tufted and bonded carpet floor coverings

Install unpatterned tufted and bonded carpet floor coverings

Unit of competency
National Code
MSFFL2018
State Code
WI348
TGA Status
Replaced
DTWD Status
Replaced
Current Release Number
1.00
Current Release Date
10/12/2013
View on TGA
State Implementation and Classification
Approved Date
19/06/2014
Field of Education
040321 - Floor Coverings
Original Release Date
19/06/2014
Nominal Hours
36
Description
This unit of competency covers installing unpatterned tufted and bonded carpet floor coverings, including preparing, cutting, laying out, joining, power stretching, trimming and finishing, using the carpet gripper installation system.Licensing, legislative or certification requirements may apply to this unit and relevant state/territory and local government agencies should be consulted to determine any necessary certification or licensing for undertaking flooring work. Access to construction sites requires certification of general induction training specified by the National Code of Practice for Induction for Construction Work (ASCC 2007).
Notes
Elements and Performance Criteria
1 Prepare for installation
  • 1.1 Applicable work health and safety (WHS), legislative and organisational requirements relevant to the installation of unpatterned tufted and bonded carpet floor coverings are verified and complied with
  • 1.2 Instructions and/or plans/sketchers are read and interpreted to identify the process required to complete work tasks
  • 1.3 Tools, equipment and materials are selected and checked prior to use to ensure that they are appropriate for the work, serviceable and in a safe condition
  • 1.4 Sequence of work is planned, including the starting point, to ensure efficiency and quality of installation
2 Set out materials
  • 2.1 Carpet to be installed is checked against order
  • 2.2 Carpet is acclimatised according to manufacturer recommendations
  • 2.3 Underlay and gripper strips are inspected to confirm correct fitting
  • 2.4 Work area is cleared of scraps or other contaminants
3 Lay carpet
  • 3.1 Instructions and sequence for laying and fixing are followed
  • 3.2 Carpet pieces are laid out and checked for size, direction of pile match
  • 3.3 Carpet pieces are cut, sealed and joined
  • 3.4 Stretching and fixing methods are used following manufacturer instructions and Australian Standards
  • 3.5 Finished work is inspected for compliance with work order, workplace and Australian Standards of finish
4 Complete housekeeping
  • 4.1 Unused materials are stored or recycled as required
  • 4.2 Tools and equipment are cleaned and stored appropriately
  • 4.3 Work area is cleaned and rubbish disposed of appropriately
  • 4.4 Workplace documentation is completed
No information
No information
Replaces
State Code National Code Title Type
W8541 LMFFL2202A Install unpatterned tufted and bonded carpet floor coverings Unit of competency
Replaced By
State Code National Code Title Type
OAJ86 MSFFL2037 Install unpatterned tufted carpet Unit of competency
State Code National Code Title Type
J736 MSF30813 Certificate III in Flooring Technology Qualification
J725 MSF20113 Certificate II in Furnishing Qualification