Unit of competency Outline

Date retreived
23/07/2026 1:09 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Create composite laminates using hand lay-up techniques

Create composite laminates using hand lay-up techniques

Unit of competency
National Code
PMBPROD247E
State Code
ODB27
TGA Status
Current
DTWD Status
Approved
Current Release Number
1.00
Current Release Date
18/02/2021
View on TGA
State Implementation and Classification
Approved Date
19/05/2021
Field of Education
030305 - Materials Engineering
Original Release Date
19/05/2021
Nominal Hours
52
Description
This unit describes the applied skills and knowledge required to create polymer-matrix laminates using manual hand lay-up techniques.This unit applies to an individual working alone or as part of a team.The unit principally refers to the introductory level of competency required for the application of composites technology.No licensing or certification requirements exist at the time of publication. Relevant legislation, industry standards and codes of practice within Australia must be applied.
Notes
Elements and Performance Criteria
1. Check work requirements
  • 1.1 Identify requirements from job specifications
  • 1.2 Perform housekeeping tasks to prepare for work to be undertaken
  • 1.3 Perform pre-operational checks including checking for and acting on hazards
2. Set up mould and materials
  • 2.1 Set up mould ready for production
  • 2.2 Ensure materials are available in form and quantities required
  • 2.3 Ensure safety equipment is available and fit for use
3. Lay-up composites by hand
  • 3.1 Apply materials to mould according to specifications
  • 3.2 Ensure output meets job specifications and quality standards
  • 3.3 Work efficiently to minimise scrap and trim
  • 3.4 Clean equipment and work area according to equipment specifications and workplace procedures
4. Respond to process control variances
  • 4.1 Recognise and log process control variances and their causes
  • 4.2 Determine, prioritise and implement remedial and preventative actions based on identified issues and causes
  • 4.3 Maintain records and logbooks
No information
No information
Replaces
State Code National Code Title Type
BAJ16 PMBPROD247 Hand lay up composites Unit of competency