Unit of competency Outline

Date retreived
23/07/2026 6:01 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Fabricate and install automotive and marine floor coverings

Fabricate and install automotive and marine floor coverings

Unit of competency
National Code
AURVTT017
State Code
AWZ05
TGA Status
Current
DTWD Status
Approved
Current Release Number
1.00
Current Release Date
14/04/2016
View on TGA
State Implementation and Classification
Approved Date
13/07/2016
Field of Education
030513 - Upholstery And Vehicle Trimming
Original Release Date
13/07/2016
Nominal Hours
40
Description
This unit describes the performance outcomes required to measure, mark out, and cut, and fabricate and install automotive or marine floor coverings. It involves preparing for the task, selecting and using specialist tools and equipment, selecting materials and checking their quality, following manufacturer and customer instructions, and completing workplace processes and documentation.It applies to those working in the automotive and marine trimming service and repair industry.No licensing, legislative, regulatory or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1. Prepare for fabrication of floor coverings
  • 1.1 Job requirements are determined from workplace instructions
  • 1.2 Fabrication methods and materials are selected and inspected for quality and quantities are calculated
  • 1.3 Hazards associated with the work are identified and risks are managed
  • 1.4 Tools and equipment, including personal protective equipment (PPE), are selected and checked for serviceability
  • 1.5 Work is planned to minimise waste and use time efficiently
2. Measure, fabricate and install floor coverings
  • 2.1 Work area is prepared and fabrication tools and equipment are set up for job requirement
  • 2.2 Materials are measured, marked out and cut according to floor covering specifications and patterns, workplace procedures, and safety and environmental requirements
  • 2.3 Floor coverings are fabricated and fabrication process is monitored to ensure specifications, customer requirements, and workplace procedures are met
  • 2.4 Defects, quality issues and non-conformances are reported to authorised personnel according to workplace procedures
  • 2.5 Installation and fitting of floor coverings, insulation and fastenings are completed according to workplace procedures and job requirements
3. Complete work processes
  • 3.1 Final inspection is made to ensure work meets workplace expectations and vehicle is presented ready for use
  • 3.2 Work area is cleaned, waste and non-recyclable materials are disposed of, and recyclable material is collected and stored
  • 3.3 Tools and equipment are checked, reported if faulty, and stored according to workplace procedures
  • 3.4 Workplace documentation is processed according to workplace procedures
No information
No information
Replaces
State Code National Code Title Type
WF569 AURVTT3017 Fabricate and install floor coverings Unit of competency