Unit of competency Outline

Date retreived
23/07/2026 2:05 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Trim new panels to size

Trim new panels to size

Unit of competency
National Code
FWPWPP3221
State Code
AXJ16
TGA Status
Replaced
DTWD Status
Replaced
Current Release Number
1.00
Current Release Date
13/05/2016
View on TGA
State Implementation and Classification
Approved Date
05/10/2016
Field of Education
030111 - Wood MacHining And Turning
Original Release Date
05/10/2016
Nominal Hours
15
Description
This unit of competency describes the outcomes required to trim new panels to size with automated trimming saws as they progress along the production line.The unit applies to production operators and technicians who trim new panels to size in a forest and wood products factory setting and includes operator maintenance.No licensing, legislative, regulatory, or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1. Prepare for trimming
  • 1.1 Review work order and where required check with appropriate personnel.
  • 1.2 Select personal protective and other equipment and check for operational effectiveness.
  • 1.3 Plan material trimming sequences in line with work order.
2. Trim panels to size
  • 2.1 Use equipment in line with organisational safety procedures, manufacturer’s instructions and environmental protection practices.
  • 2.2 Set feed system to stop material automatically for trimming to be completed.
  • 2.3 Monitor trimming sequence until new panel production run ceases.
  • 2.4 Check cuts for length within set tolerance.
  • 2.5 Dispose of incorrect cuts, off cuts and defective material in line with environmental protection practices.
  • 2.6 Stack material safely in designated location in line with work order.
3. Complete operator maintenance
  • 3.1 Follow organisational safety procedures to lock out equipment
  • 3.2 Check saw blades for bluntness or damage.
  • 3.3 Remove and replace saw blades in line with manufacturer's recommendations.
  • 3.4 Keep saw area clear of dust, off-cuts and debris in line with organisational safety procedures.
  • 3.5 Record and report production outcomes, equipment faults and maintenance requirements to appropriate personnel.
No information
No information
Replaces
State Code National Code Title Type
D6136 FPIWPP3221B Trim new panels to size Unit of competency
Replaced By
State Code National Code Title Type
OAM06 FWPWPP3235 Trim new engineered wood panels to size Unit of competency
State Code National Code Title Type
BAL3 FWP30416 Certificate III in Wood Panel Products Qualification