Unit of competency Outline

Date retreived
24/07/2026 1:27 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Perform basic radiographic testing

Perform basic radiographic testing

Unit of competency
National Code
MEM24009
State Code
OEU41
TGA Status
Replaced
DTWD Status
Transition (Replaced)
Current Release Number
1.00
Current Release Date
19/12/2022
View on TGA
State Implementation and Classification
Approved Date
19/04/2023
Field of Education
030305 - Materials Engineering
Original Release Date
19/04/2023
Nominal Hours
18
Description
This unit of competency defines the skills and knowledge required to perform basic radiographic testing procedures and work with ionizing radiation in open and closed sites on fabrication, structures and components across a wide range of industries and industrial applications. It applies to situations where knowledge of metallurgy associated with the level of application in this unit is required.All testing must be completed with particular attention to personal and WHS regulations. Ionizing radiation equipment materials and chemicals, which are subject to codes and regulations, must be stored, used, and transported in accordance with safe work practices. This unit should not be selected when unit MEM24010 Perform radiographic testing has already been selected.Where interpretation of technical drawings is required unit MEM09002 Interpret technical drawing should also be selected.Where the selection and use of engineering measurement is required unit MEM12023 Perform engineering measurements should also be selected.Where the selection and use of power tools are required unit MEM18002 Use power tools/hand held operations should also be selected.No licensing or legislative requirements apply to this unit at the time of publication. Certification against Australian Standards may be achieved where assessment in this unit of competency is carried out in conjunction with an examining authority as described in AS ISO 9712 Non-destructive testing — Qualification and certification of NDT personnel.Band: AUnit Weight: 2
Notes
Elements and Performance Criteria
1. Determine job requirements
  • 1.1 Follow standard operating procedures (SOPs)
  • 1.2 Comply with work health and safety (WHS) requirements at all times
  • 1.3 Use appropriate personal protective equipment (PPE) in accordance with SOPs
  • 1.4 Identify job requirements from specifications
2. Prepare inspection areas ready for basic radiographic testing
  • 2.1 Clean radiographic specimens and prepare for testing using appropriate procedures and materials
  • 2.2 Carry out preparation processes in accordance with the relevant procedures
  • 2.3 Assess inspection areas visually and identify obvious discontinuities
3. Set up radiographic test equipment
  • 3.1 Identify nominated test from SOPs
  • 3.2 Set up radiation testing and processing equipment in accordance with manufacturers’ specifications
4. Carry out basic radiographic tests
  • 4.1 Identify basic properties of X-rays and gamma rays
  • 4.2 Apply safety practices and controls for minimising radiation exposure
  • 4.3 Operate radiographic testing and safety equipment in accordance with relevant work instructions
  • 4.4 Process films to achieve optimum results
No information
No information
Replaces
State Code National Code Title Type
W5707 MEM24009B Perform basic radiographic testing Unit of competency
Replaced By
State Code National Code Title Type
OFH46 MEM18114 Perform basic radiographic testing Unit of competency