Unit of competency Outline

Date retreived
23/07/2026 9:01 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Saw products from continuous ply

Saw products from continuous ply

Unit of competency
National Code
FWPWPP2209
State Code
AXJ42
TGA Status
Deleted
DTWD Status
Deleted
Current Release Number
1.00
Current Release Date
13/05/2016
View on TGA
State Implementation and Classification
Approved Date
05/10/2016
Field of Education
030111 - Wood MacHining And Turning
Original Release Date
05/10/2016
Nominal Hours
10
Description
This unit of competency describes the outcomes required to use a power driven saw to saw panels to size from a roll of continuous ply.The unit applies to production workers who saw products from continuous ply in a forest and wood products factory setting and includes operator maintenance.No licensing, legislative, regulatory, or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1. Prepare for cutting
  • 1.1 Review work order and where required check with appropriate personnel.
  • 1.2 Select appropriate personal protective and other equipment and check for operational effectiveness.
  • 1.3 Obtain type and quantity of continuous ply to be cut from storage location.
  • 1.4 Plan material cutting patterns and saw set-up sequences in line with work order.
2. Cut continuous ply to size
  • 2.1 Use equipment in line with organisational safety procedures, manufacturer’s instructions and environmental protection practices.
  • 2.2 Mark material and set stops in preparation for cutting.
  • 2.3 Set-up ply on in-feed and feed systems, check and regularly adjust rate.
  • 2.4 Follow cutting sequence and patterns to produce required quantity.
  • 2.5 Check cuts for length or angle within set tolerance.
  • 2.6 Dispose of incorrect cuts, off cuts and defective material in line with environmental protection practices.
  • 2.7 Stack material safely in designated location in line with work order.
3. Complete operator maintenance
  • 3.1 Follow organisational safety procedures to lock out equipment.
  • 3.2 Check saw blades for bluntness or damage.
  • 3.3 Remove and replace saw blades in line with manufacturer's recommendations.
  • 3.4 Dispose of used blades in line with environmental protection practices.
  • 3.5 Keep work area clear of dust and debris in line with organisational safety procedures.
  • 3.6 Record and report production outcomes, equipment faults and maintenance requirements to appropriate personnel.
No information
No information
Replaces
State Code National Code Title Type
D6113 FPIWPP2209B Saw products from continuous ply Unit of competency
State Code National Code Title Type
BAK9 FWP20416 Certificate II in Wood Panel Products Qualification