Unit of competency Outline

Date retreived
23/07/2026 11:41 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Mount and proof flexographic plates for basic printing

Mount and proof flexographic plates for basic printing

Unit of competency
National Code
ICPPRN2110
State Code
OBP75
TGA Status
Current
DTWD Status
Approved
Current Release Number
1.00
Current Release Date
06/05/2020
View on TGA
State Implementation and Classification
Approved Date
20/08/2020
Field of Education
030103 - Printing
Original Release Date
20/08/2020
Nominal Hours
30
Description
This unit describes the skills and knowledge required to prepare and mount flexographic plates and plate cylinders for routine printing including proofing plates and checking cylinders for registration.It applies to individuals who work under direct supervision and perform a range of routine printing tasks in a defined context. The practical skills and operational knowledge required to perform these tasks is at a fundamental level.No licensing, legislative or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1. Prepare for job
  • 1.1 Identify job specifications
  • 1.2 Carry out set up of required machinery according to manufacturer specifications
  • 1.3 Complete and sign off on required prior inspections
2. Prepare flexographic plates
  • 2.1 Measure plate height and relief
  • 2.2 Trim and prepare plates according to mounting system requirements
  • 2.3 Select mounting adhesive according to pitch circle diameter (PCD) of specified plate cylinders and gears
3. Prepare plate cylinders
  • 3.1 Select, clean and prepare plate cylinders and seamless sleeves as required
  • 3.2 Select, clean, prepare and mount sleeves and gears on mandrels according to job specifications
  • 3.3 Check total indicated run-out (TIR) is within specified tolerances on plate cylinders
  • 3.4 Select and apply mounting adhesive to plate cylinders
4. Mount and proof flexographic plates on machine
  • 4.1 Prepare plates and mount on cylinders
  • 4.2 Prepare plate mounting sheet according to job specifications and registration requirements
  • 4.3 Mount plates to required position
  • 4.4 Install plate mounting sheet and tension onto plate cylinder
  • 4.5 Proof plates and check each plate cylinder for register
  • 4.6 Trim and tape down flexographic plates according to printing press requirements
No information
No information
Replaces
State Code National Code Title Type
AUP02 ICPPRN211 Mount and proof flexographic plates for basic printing Unit of competency