Unit of competency Outline

Date retreived
23/07/2026 2:07 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Construct cane furniture

Construct cane furniture

Unit of competency
National Code
MSFFM2009
State Code
WI418
TGA Status
Deleted
DTWD Status
Deleted
Current Release Number
1.00
Current Release Date
10/12/2013
View on TGA
State Implementation and Classification
Approved Date
19/06/2014
Field of Education
030113 - Cabinet Making
Original Release Date
19/06/2014
Nominal Hours
84
Description
This unit of competency covers constructing and assembling cane furniture.No licensing, legislative or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1 Prepare for work
  • 1.1 Work health and safety (WHS) requirements, including personal protection needs, are observed throughout the work
  • 1.2 Tools, machines and materials are selected and checked prior to use to ensure that they are appropriate for the work, serviceable and in a safe condition
  • 1.3 Furniture design, tolerances, process, materials and quantities are determined from work instructions
  • 1.4 Construction and assembly sequence is planned
  • 1.5 Procedures are determined for checking quality at each stage of the process
  • 1.6 Suitable work area is selected for the task
  • 1.7 Preparatory drawings/set-outs for tasks are completed
  • 1.8 Cutting list for components is developed
  • 1.9 Materials are selected following work instructions
2 Complete construction
  • 2.1 Material is set out and prepared according to work instructions and components are marked according to workplace procedures
  • 2.2 Tools, machines and equipment are used in accordance with safety requirements and manufacturer specifications
  • 2.3 Components are manufactured, including any specified shapes, angles or curves, and checked against set-out and job requirements
  • 2.4 Components are assembled using jigs and/or clamps and fastenings
  • 2.5 Adhesives are applied according to workplace procedures and/or manufacturer instructions
  • 2.6 Joining process is undertaken according to workplace procedures
  • 2.7 Assembled furniture is checked for compliance with specifications
  • 2.8 Furniture is prepared for finishing
  • 2.9 Any non-conformity with the required quality standards is rectified
3 Finalise operation and maintain equipment
  • 3.1 Work area is cleaned, hand and/or power tools and equipment are cleaned, maintained and stored in accordance with workplace procedures
  • 3.2 Machinery is cleaned and left in a safe mode
  • 3.3 Faulty and/or defective equipment is tagged and reported in accordance with workplace practices
  • 3.4 Unused hardware is collected and stored for re-use or disposal following workplace procedures
  • 3.5 Waste and scrap materials are dealt with following workplace procedures
No information
No information
Replaces
State Code National Code Title Type
W8606 LMFFM2009B Construct cane furniture Unit of competency
State Code National Code Title Type
J727 MSF20313 Certificate II in Furniture Making Qualification
J730 MSF30213 Certificate III in Furniture Making Qualification