Unit of competency Outline
Date retreived
22/07/2026 8:48 PM AWST
22/07/2026 8:48 PM AWST
Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.
Carry out oxyacetylene welding, thermal heating and cutting
Carry out oxyacetylene welding, thermal heating and cutting
Unit of competency
National Code
AURVTW008
AURVTW008
State Code
AWY95
AWY95
TGA Status
Replaced
Replaced
DTWD Status
Replaced
Replaced
State Implementation and Classification
Approved Date
13/07/2016
Field of Education
030711 - Boilermaking And Welding
Original Release Date
13/07/2016
Nominal Hours
30
Description
This unit describes the performance outcomes required to carry out basic welding, thermal heating and cutting operations. It involves preparing for the task, setting up and operating an oxyacetylene plant, setting gas pressures, identifying and adjusting flame appropriate for welding, thermal heating or cutting requirements, selecting and using suitable personal protective equipment (PPE), and completing workplace processes and documentation.It applies to those working in the automotive service and repair industry.No licensing, legislative, regulatory or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1. Plan and prepare for oxyacetylene welding, thermal heating and cutting
- 1.1 Job requirements are determined from workplace instructions
- 1.2 Technical information and workplace procedures relating to oxyacetylene, welding, thermal heating and cutting are accessed and interpreted
- 1.3 Hazards associated with the work are identified and risks are managed
- 1.4 Tools and equipment, including PPE, are selected and checked for serviceability
- 1.5 Welding, thermal heating or cutting is planned to minimise waste and use time efficiently
2. Weld, thermal heat and cut using oxyacetylene plant
- 2.1 Oxyacetylene gas working pressure adjustment and flame identification and setting are carried out according to workplace instructions and procedures
- 2.2 Welding, thermal heating and cutting is carried out without causing damage to property, vehicle or components
- 2.3 Welding, thermal heating and cutting operations are conducted according to job requirements, workplace procedures, and safety and environmental requirements
3. Complete the job
- 3.1 Final inspection is made to ensure work meets workplace expectations and component is presented ready for use
- 3.2 Work area is cleaned, waste and non-recyclable materials are disposed of, and recyclable material is collected and stored
- 3.3 Tools and equipment are checked, reported if faulty, and stored according to workplace procedures
- 3.4 Workplace documentation is processed according to workplace procedures
No information
No information
Replaces
| State Code | National Code | Title | Type |
|---|---|---|---|
| WF581 | AURVTW2008 | Carry out oxy acetylene welding, thermal cutting and thermal heating procedures | Unit of competency |
Replaced By
| State Code | National Code | Title | Type |
|---|---|---|---|
| OAK17 | AURVTW018 | Carry out oxyacetylene welding, thermal heating and cutting | Unit of competency |