Unit of competency Outline

Date retreived
23/07/2026 4:12 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Clean plastic trim and fittings of vehicles

Clean plastic trim and fittings of vehicles

Unit of competency
National Code
AURVTT007
State Code
AWZ14
TGA Status
Current
DTWD Status
Approved
Current Release Number
1.00
Current Release Date
14/04/2016
View on TGA
State Implementation and Classification
Approved Date
13/07/2016
Field of Education
039909 - Cleaning
Original Release Date
13/07/2016
Nominal Hours
20
Description
This unit describes the performance outcomes required to clean a vehicle’s plastic trim and fittings. It involves preparing for the task, selecting and using cleaning equipment and material, cleaning the trim and fittings, and completing workplace processes and documentation.It applies to those working in the automotive service and repair industry.No licensing, legislative, regulatory or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1. Prepare to clean plastic trim and fittings
  • 1.1 Job requirements are determined from workplace instructions
  • 1.2 Cleaning materials are selected according to vehicle and product manufacturer recommendations and workplace procedures
  • 1.3 Hazards associated with the work are identified and risks are managed
  • 1.4 Cleaning equipment, including personal protective equipment (PPE), is selected and checked for serviceability
  • 1.5 Work is planned to identify manual or machine methods for cleaning plastic trim and fittings, minimise waste, and use time efficiently
2. Carry out cleaning activities
  • 2.1 Cleaning materials are prepared and applied according to workplace procedures, safety data sheet (SDS) information, and safety and environmental requirements
  • 2.2 Plastic trim and fittings are cleaned according to workplace instructions and customer requirements, and without causing damage to vehicle or components
3. Complete work processes
  • 3.1 Final inspection is made to ensure work meets workplace expectations and vehicle is presented ready for use
  • 3.2 Work area is cleaned, waste and non-recyclable materials are disposed of, and recyclable material is collected and stored
  • 3.3 Tools and equipment are checked, reported if faulty, and stored according to workplace procedures
  • 3.4 Workplace documentation is processed according to workplace procedures
No information
No information
Replaces
State Code National Code Title Type
WF559 AURVTT2007 Clean and finish plastic trim and fittings Unit of competency