Unit of competency Outline

Date retreived
22/07/2026 9:26 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Fabricate synthetic solid surface products

Fabricate synthetic solid surface products

Unit of competency
National Code
MSFFM3020
State Code
WI441
TGA Status
Replaced
DTWD Status
Replaced
Current Release Number
1.00
Current Release Date
10/12/2013
View on TGA
State Implementation and Classification
Approved Date
19/06/2014
Field of Education
030113 - Cabinet Making
Original Release Date
19/06/2014
Nominal Hours
36
Description
This unit of competency covers fabricating synthetic solid surface furniture and furnishing products.No licensing, legislative or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1 Prepare for work
  • 1.1 Work instructions are used to determine job requirements, including design, tolerances, process, materials, finish and quantity
  • 1.2 Fabrication sequence is planned
  • 1.3 Procedures are determined for checking quality at each stage of the process
  • 1.4 Work health and safety (WHS) requirements, including personal protection needs, are observed throughout the work
  • 1.5 Suitable work area is selected for the task
  • 1.6 Preparatory drawings and set-outs for tasks are completed
  • 1.7 Cutting list for components is developed
  • 1.8 Materials are selected following work instructions
  • 1.9 Tools and equipment suitable for fabrication are identified and checked for safe and effective operation
2 Complete fabrication
  • 2.1 Materials are set out and prepared according to work instructions and components are marked according to industry practices
  • 2.2 Tools, machines and equipment are used in accordance with safety requirements and manufacturer specifications
  • 2.3 Components are fabricated and checked against set-outs for accuracy tolerances, fit and distortion
  • 2.4 Doors, drawers, shelves or decorative treatments are fitted as required
  • 2.5 Product is prepared for final finish, including the removal of bruises, scratches, dents and marks
  • 2.6 Product is checked against plans at identified checkpoints
3 Finalise operation and maintain equipment
  • 3.1 Work area is cleaned, hand and/or power tools and equipment are cleaned, maintained and stored in accordance with workplace procedures
  • 3.2 Machinery is cleaned and left in a safe mode
  • 3.3 Faulty and/or defective equipment is tagged and reported in accordance with workplace practices
  • 3.4 Unused hardware is collected and stored for re-use or disposal following workplace procedures
  • 3.5 Waste and scrap materials are dealt with following workplace procedures
No information
No information
Replaces
State Code National Code Title Type
W8629 LMFFM3028B Fabricate synthetic solid surface products Unit of competency
Replaced By
State Code National Code Title Type
OEK52 MSFFM3039 Fabricate synthetic solid surface products Unit of competency