Unit of competency Outline

Date retreived
22/07/2026 4:49 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Match and join veneer

Match and join veneer

Unit of competency
National Code
FWPWPP3205
State Code
AXJ34
TGA Status
Deleted
DTWD Status
Deleted
Current Release Number
1.00
Current Release Date
13/05/2016
View on TGA
State Implementation and Classification
Approved Date
05/10/2016
Field of Education
030111 - Wood MacHining And Turning
Original Release Date
05/10/2016
Nominal Hours
10
Description
This unit of competency describes the outcomes required to match, stitch, tape or glue slices of veneer in readiness for bonding to panel products.The unit applies to production operators and technicians who match and join veneer in a forest and wood products factory setting.No licensing, legislative, regulatory, or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1. Prepare for joining veneer
  • 1.1 Review work order and where required check with appropriate personnel.
  • 1.2 Select appropriate personal protective equipment and check for operational effectiveness.
  • 1.3 Obtain type and quantity of veneer for matching and joining from veneer production process.
  • 1.4 Select matching and joining process in line with work order.
2. Match and join veneer
  • 2.1 Use equipment in line with organisational safety procedures, manufacturer’s instructions and environmental protection practices.
  • 2.2 Complete pre start-up equipment checks to ensure operational effectiveness.
  • 2.3 Set machine functions and feed rate for optimal product recovery.
  • 2.4 Select joining method in line with veneer to be matched.
  • 2.5 Inspect sheets visually and match veneer to specification.
  • 2.6 Clip sheets to provide clean edges and join in line with work order.
  • 2.7 Assess veneer visually throughout joining process for strength and production defects.
3. Redistribute material
  • 3.1 Assess joins and grade veneer in line with organisational procedures and industry standards.
  • 3.2 Direct material to storage or processing operations in line with organisational procedures.
  • 3.3 Dispose of sub-standard material and excess glue in line with environmental protection practices.
  • 3.4 Clean work area and store unused glue in line with organisational safety procedures.
  • 3.5 Record and report production outcomes and equipment faults to appropriate personnel.
No information
No information
Replaces
State Code National Code Title Type
D6120 FPIWPP3205B Match and join veneer Unit of competency
State Code National Code Title Type
BAL3 FWP30416 Certificate III in Wood Panel Products Qualification