Unit of competency Outline

Date retreived
23/07/2026 5:55 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Diagnose faults in electronic security equipment and systems

Diagnose faults in electronic security equipment and systems

Unit of competency
National Code
CPPSEC3039
State Code
OBI94
TGA Status
Current
DTWD Status
Approved
Current Release Number
1.00
Current Release Date
30/09/2019
View on TGA
State Implementation and Classification
Approved Date
20/05/2020
Field of Education
029901 - Security Science
Original Release Date
20/05/2020
Nominal Hours
20
Description
This unit specifies the skills and knowledge required to diagnose faults in electronic security equipment and systems. It includes applying methodical diagnostic procedures, testing suspected fault scenarios, and assessing test results, historical information and operational data to diagnose faults and recommend options for rectification. This work applies in extra low voltage environments as defined in Australian Standard AS/NZS2201.1:2007 Intruder alarm systems - Client’s premises - Design, installation, commissioning and maintenance (AS/NZS 2201).A person working at this level would be expected to take responsibility for organising and completing tasks assigned to them without close supervision.Licensing, legislative or certification requirements apply to advising on, supplying, installing, maintaining, monitoring, repairing and servicing security equipment in some states and territories. For further information, check with the relevant regulatory authority.
Notes
Elements and Performance Criteria
1 Prepare to diagnose electronic security equipment and system faults.
  • 1.1 Review work instructions to confirm client requirements and diagnostic timeframes.
  • 1.2 Review AS/NZS 2201 to understand regulatory requirements associated with diagnosing security equipment and system faults and apply to work instructions.
  • 1.3 Use questioning and active listening to gather information on type of security equipment and system and extent of fault.
  • 1.4 Review and follow workplace policies and procedures including work health and safety when carrying out work tasks.
2 Plan and organise work tasks.
  • 2.1 Plan and prioritise work tasks allowing sufficient time to meet work instructions.
  • 2.2 Select and organise required materials, tools and equipment including personal protective equipment and check for safe and correct operation.
  • 2.3 Arrange access to security equipment and system in consultation with relevant persons.
  • 2.4 Identify hazards in the work area and apply risk control measures.
3 Conduct electronic security equipment and system testing and diagnostic procedures.
  • 3.1 Use safe work practices when working with electronic equipment and cables according to WHS requirements.
  • 3.2 Isolate security equipment and system according to WHS requirements.
  • 3.3 Confirm normal performance of security equipment and system against specification schedules.
  • 3.4 Inspect and check security system components and test operation according to manufacturers’ instructions.
  • 3.5 Methodically apply diagnostic methods using measurements and estimations of system operating parameters.
  • 3.6 Test suspected fault scenarios to identify source of system problems.
  • 3.7 Assess test data, site variables, operational and historical information to support fault diagnosis.
  • 3.8 Diagnose fault or seek assistance from relevant persons to meet work instructions.
4 Recommend options for fault rectification and complete documentation.
  • 4.1 Document diagnosed faults and options for fault rectification that are supported by verifiable data according to workplace and regulatory requirements.
  • 4.2 Check tools and equipment for faults, wear or damage and rectify or report problems.
  • 4.3 Clean and restore work area and remove waste caused by work tasks.
No information
No information
Replaces
State Code National Code Title Type
D1440 CPPSEC3039A Identify and diagnose electronic security equipment and system fault Unit of competency