Unit of competency Outline

Date retreived
23/07/2026 1:32 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Troubleshoot analog and digital electronic equipment

Troubleshoot analog and digital electronic equipment

Unit of competency
National Code
MEM18108
State Code
AUX44
TGA Status
Current
DTWD Status
Approved
Current Release Number
2.00
Current Release Date
26/06/2019
View on TGA
State Implementation and Classification
Approved Date
16/10/2015
Field of Education
031317 - Electronic Equipment Servicing
Original Release Date
16/10/2015
Nominal Hours
36
Description
This unit has been developed for Engineering Tradesperson - industrial electrician apprenticeship training and the recognition of trade-level skills in troubleshooting analog/digital electronic equipment down to sub-assembly and/or card level where a series of checks and pre-determined tests is applied in accordance with workshop manuals and testing procedures. It applies to a wide range of electronic systems and sub-assemblies used in an industrial environment.No licensing, legislative or certification requirements apply to this unit at the time of publication.Band: AUnit Weight: 4
Notes
Elements and Performance Criteria
1. Determine job requirements
  • 1.1 Follow standard operating procedures (SOPs)
  • 1.2 Comply with work health and safety (WHS) requirements at all times
  • 1.3 Use appropriate personal protective equipment (PPE) in accordance with SOPs
  • 1.4 Identify job requirements from specifications, drawings, job sheets or work instructions
2. Troubleshoot electronic equipment
  • 2.1 Determine the function of electronic equipment by reference to circuit diagrams, equipment manuals and/or consultation with equipment operator, where appropriate
  • 2.2 Run equipment built-in test functions and record results, where appropriate
  • 2.3 Note and record built-in faults/status display
  • 2.4 Apply diagnostic techniques to locate faults in electronic equipment, including the use of specialist test equipment
  • 2.5 Isolate and remove faulty card or sub-assembly from electronic system using appropriate tools and techniques
  • 2.6 Source replacement item and replace in accordance with manufacturer specifications
3. Return electronic equipment to service
  • 3.1 Adjust/tune or calibrate electronic equipment for conformance to specifications, where appropriate
  • 3.2 Test repaired equipment/sub-assemblies for compliance to specifications and/or manufacturer requirements
  • 3.3 Complete all documentation requirements according to SOPs
No information
No information
No information