Unit of competency Outline

Date retreived
23/07/2026 1:56 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Perform routine flux core arc welding

Perform routine flux core arc welding

Unit of competency
National Code
MEM05056
State Code
OAW67
TGA Status
Current
DTWD Status
Approved
Current Release Number
2.00
Current Release Date
04/09/2025
View on TGA
State Implementation and Classification
Approved Date
Field of Education
030711 - Boilermaking And Welding
Original Release Date
Nominal Hours
18
Description
This unit of competency defines the skills and knowledge required to prepare the materials and carry out routine flux core arc welding (FCAW) and applies in a maintenance or manufacturing environment where the weld quality is not required to meet an Australian Standard.Where welding is required to meet AS 1554 General Purpose or equivalent codes, work health and safety (WHS) regulations and/or licensing requirements unit MEM05096 Weld using flux core arc welding process should also be selected.Where the interpretation of technical drawings is required unit MEM09002 Interpret technical drawing should also be selected.Where the selection and use of engineering measurement is required unit MEM12023 Perform engineering measurements should also be selected.Where the selection and use of tools is required unit MEM18001 Use hand tools and unit MEM18002 Use power tools/hand held operations, should also be selected as appropriate.Band: AUnit Weight: 2
Notes
Elements and Performance Criteria
1. Determine job requirements
  • 1.1 Follow standard operating procedures (SOPs)
  • 1.2 Comply with work health and safety (WHS) requirements at all times
  • 1.3 Use appropriate personal protective equipment (PPE) in accordance with SOPs
  • 1.4 Identify job requirements from specifications, sketches, job sheets or work instructions
2. Prepare materials and equipment for welding
  • 2.1 Identify location of welds in accordance with procedures and job specifications
  • 2.2 Clean and prepare materials ready for welding
  • 2.3 Set up welding equipment to meet work requirement
  • 2.4 Select settings and consumables to suit application
3. Perform routine welding using FCAW
  • 3.1 Weld materials to job requirements
  • 3.2 Clean welds according to SOPs
No information
No information
No information