Unit of competency Outline

Date retreived
23/07/2026 6:39 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Cut and handle glazing materials for framing

Cut and handle glazing materials for framing

Unit of competency
National Code
MSFPF2013
State Code
OAI43
TGA Status
Current
DTWD Status
Approved
Current Release Number
1.00
Current Release Date
03/12/2018
View on TGA
State Implementation and Classification
Approved Date
22/05/2019
Field of Education
030199 - Manufacturing Engineering And Technology, N.e.c.
Original Release Date
22/05/2019
Nominal Hours
24
Description
This unit describes the skills and knowledge required to cut and handle glazing materials, including acrylic sheet, for picture and mirror frames. This unit applies to picture framers cutting glazing materials in accordance with pre-determined frame designs.No licensing or certification requirements exist at the time of publication. Relevant legislation, industry standards and codes of practice within Australia must be applied.
Notes
Elements and Performance Criteria
1. Prepare for work
  • 1.1 Read work order and identify glazing requirements
  • 1.2 Identify and follow work health safety requirements throughout the work
  • 1.3 Select and check tools and equipment for quality, serviceability and safety prior to use
  • 1.4 Locate required glazing material and check for imperfections and damage prior to handling
  • 1.5 Handle glazing material in accordance with safety requirements and any labelling instructions
  • 1.6 Select and clear work area of obstructions and potential hazards
  • 1.7 Plan sequence of work to ensure cutting is conducted in a logical order
2. Cut glazing materials
  • 2.1 Accurately measure glazing material to minimise waste and ensure specified tolerances in accordance with workplace standards
  • 2.2 Achieve required product quality and output through correct operation and monitoring of glazing equipment and tools
  • 2.3 Complete routine machine lubrication and adjustments in accordance with manufacturer instructions
  • 2.4 Identify and report problems occurring during work operations to appropriate persons
  • 2.5 Inspect completed work for compliance with quality and work order requirements and rectify any deficiencies
3. Complete work
  • 3.1 Mark completed work for identification and store in accordance with workplace procedures
  • 3.2 Identify and store items for recycling in accordance with workplace procedures
  • 3.3 Clean work area and safely dispose of rubbish
  • 3.4 Accurately complete required workplace documentation
  • 3.5 Check, clean and store tools and equipment in accordance with workplace procedures
No information
No information
Replaces
State Code National Code Title Type
WI585 MSFPF2006 Cut and handle glazing materials for framing Unit of competency
State Code National Code Title Type
J725 MSF20113 Certificate II in Furnishing Qualification
BIJ6 MSF20122 Certificate II in Furnishing Qualification
BED4 MSF30518 Certificate III in Picture Framing Qualification