Unit of competency Outline

Date retreived
23/07/2026 12:20 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Set and edit computer controlled machines and processes

Set and edit computer controlled machines and processes

Unit of competency
National Code
MEM07016
State Code
OAW38
TGA Status
Current
DTWD Status
Approved
Current Release Number
2.00
Current Release Date
31/03/2021
View on TGA
State Implementation and Classification
Approved Date
Field of Education
030707 - Metal Fitting, Turning And MacHining
Original Release Date
Nominal Hours
36
Description
This unit of competency defines the skills and knowledge required to set and edit computer controlled machines and processes.Work is performed to established processes, practices and specifications and machine operations, including welding, metal cutting, forming and shaping. Technical difficulties are resolved in consultation with appropriate technical advisers. Where setting and editing of computer controlled thermal cutting machines is required unit MEM05053 Set and edit computer controlled thermal cutting machines should also be selected.Where additional machining skills in excess of unit MEM07005 Perform general machining are required then appropriate units should also be selected.Where the selection and use of power tools/hand held operations is required unit MEM18002 Use power tools/hand held operations should also be selected.No licensing, legislative or certification requirements apply to this unit at the time of publication. Band: This unit has dual status and is to be regarded as both a Specialisation Band A unit and Specialisation Band B unit for progression to C7 (AQF level IV).Unit Weight: 4
Notes
Elements and Performance Criteria
1 Determine job requirements
  • 1.1 Follow standard operating procedures (SOPs)
  • 1.2 Comply with work health and safety (WHS) requirements at all times
  • 1.3 Use appropriate personal protective equipment (PPE) in accordance with SOPs
  • 1.4 Identify job requirements from specifications, drawings, job sheets or work instructions
2 Set work holding fixtures/devices/tools
  • 2.1 Select correct ancillary devices and attach to machine
  • 2.2 Prepare machine to accept work holding devices
  • 2.3 Set work holding fixtures/devices/tools to zero or a datum using appropriate setting devices
  • 2.4 Measure tooling offsets and record in machine controller
3 Trial program
  • 3.1 Operate machine to produce first-off samples, observing all safety procedures
  • 3.2 Check first-off samples for compliance with specifications
  • 3.3 Undertake program editing to change speeds, feed and operational sequence requirements to ensure job conforms to specification
  • 3.4 Replace tools, adjust tool offsets or take other corrective action using SOPs, where appropriate
  • 3.5 Instruct operator, if necessary, ensuring that all safety procedures and devices are in place
No information
No information
Replaces
State Code National Code Title Type
W5361 MEM07016C Set and edit computer controlled machines/processes Unit of competency