Unit of competency Outline

Date retreived
22/07/2026 1:43 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Apply graining and decorative finishes

Apply graining and decorative finishes

Unit of competency
National Code
MSFFF3007
State Code
WI327
TGA Status
Replaced
DTWD Status
Replaced
Current Release Number
1.00
Current Release Date
10/12/2013
View on TGA
State Implementation and Classification
Approved Date
19/06/2014
Field of Education
030117 - Furniture Polishing
Original Release Date
19/06/2014
Nominal Hours
40
Description
This unit of competency covers applying material to a surface to imitate timber grain and decorative (faux) finishesNo licensing, legislative or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1 Prepare for work
  • 1.1 Workplace information, including materials application and safety information, and material safety data sheets (MSDS), is used to inform work practices
  • 1.2 Characteristics of the surface and the required surface treatment are identified from work orders or instructions
  • 1.3 Processing and application techniques, time and safety requirements are identified and used for work planning
  • 1.4 Work health and safety (WHS) requirements, including ventilation requirements and personal protection needs, are observed throughout the work
  • 1.5 Tools, equipment and accessories are identified and checked for safe and effective operation for the task
2 Prepare for application of materials
  • 2.1 Surfaces are checked for contamination and correct preparation according to workplace procedures and standards
  • 2.2 Products with surface or other faults are identified and faults repaired as appropriate
  • 2.3 Materials required to complete the task are identified and prepared
  • 2.4 Trial applications of material are made to check equipment operation, materials consistency, viscosity and sample match
  • 2.5 Faults and or inconsistencies in colour and surface appearance are identified and workplace procedures for rectification and adjustment are followed
3 Apply finishing materials
  • 3.1 Techniques for application of graining solution and other finishes are identified
  • 3.2 Materials are applied according to job instructions, manufacturer specifications and workplace procedures
  • 3.3 Finished products are inspected and approved for suitability for further processing
  • 3.4 Products which do not meet quality specifications are rectified or tagged for further investigation
4 Clean work area and maintain equipment
  • 4.1 Equipment used is cleaned and inspected for serviceable condition and stored appropriately
  • 4.2 Unserviceable equipment is tagged, faults are identified and appropriate personnel are informed
  • 4.3 Work area is cleaned and returned to approved condition, and all areas used for bleaching are washed down with water
  • 4.4 Workplace records are completed
No information
No information
Replaces
State Code National Code Title Type
W8520 LMFFF3007B Apply graining and decorative finishes Unit of competency
Replaced By
State Code National Code Title Type
OEO88 MSFFF3016 Apply graining and decorative finishes Unit of competency
State Code National Code Title Type
J729 MSF30113 Certificate III in Furniture Finishing Qualification