Description

This qualification provides competencies to manufacture, fit, assemble, erect, operate, test, fault find, alter and repair electrical equipment and includes electrical wiring work only if that work is associated with assembling, maintaining, terminating or altering the wiring between electrical components within a plant or machinery. An electrical fitter is not authorised to install any electrical wiring systems within an electrical installation as prescribed by definitions contained in AS/NZS 3000 Electrical installations (known as the Australian/New Zealand Wiring Rules)..
Electrical equipment means any appliance, article, accessory, wire, fitting, cable, conduit or apparatus that generates, uses, conveys or controls (or that is intended to generate, use, convey or control) electricity above extra-low voltage (ELV).
The skills and knowledge described in this qualification may require a licence or permit to practice in the workplace where work is carried out on electrical installations which are designed to operate at voltages greater than 50 volt (V) alternating current (a.c.) or 120 V direct current (d.c.).
Competency development activities in this qualification may be subject to regulations directly related to licensing. Where a licence or permit to practice is not held, a relevant contract of training through an Australian Apprenticeship, may be required.
Licensing, legislative and regulatory requirements that apply to this qualification can vary between states and territories. Some jurisdictions require that the qualification is completed as an apprenticeship to obtain an Electrical Occupational License. Relevant information must be sourced prior to commencing the qualification. Where required for Licencing, the certification documentation issued must indicate if the qualification was completed as an apprenticeship or Trades Recognition Australia (TRA) pathway.